Single Room Screed Packs (Boiler)

Room Pack Summary
We believe underfloor heating should be quoted and designed on a project by project
basis. The means that we can accurately estimate the materials required for the areas
minimising construction waste. We can also make sure that the heating system is as
efficient as possible when designing each project individually.
We therefore do not offer large “multi-zone” kits, if there is more than one thermostat
and the system size is over three manifold ports (three loops) then we would prefer to
quote the project and send a detailed bespoke quotation.
0 - 20m2 - Screed
Single room, one zone pack designed to be plumbed into an existing radiator system, when the radiators are on
heat is supplied to the manifold. The pump and blending pack has an integral temperature switch so when the water
temperature from the boiler reaches 40°C the contact closes and the underfloor heating pump starts circulating water
through the underfloor heating loop. (Not suitable for microbore heating systems please call us for pipework design
suggestions)
*Please note that no air temperature controls are supplied with the kit. If air temperature controls are required, then please see the options available in the air temperature controls section. Please be aware that a 2 port motorized valve may also be required.

Luxusheat Screed System - Clips

Using the Luxusheat Prostaple gun, simply clip the pipework directly through the slip membrane to the floor grade insulation. The clips comes in two lengths of 40mm and 60mm and hold the pipework fastened during the screeding process. This is a tried and tested, cost effective solution with high outputs.

Pack Contents Include:

1x Luxusheat (UFH Only) MLC 16x2.00mm Pipe (100m)
2x 16mm x 3/4" Eurocone Pipe Connector
1x Water Temperature Control Pack (Single Pack)
1x Luxusheat Screed Floor Edge Strip (50m)
1x Luxusheat Prostaples 60mm (Box 600)